When you connect your controller to network, controller waits for IP number from DHCP for about 30 seconds. If after 30 seconds IP isn't assigned, controller gets last assigned IP number. This IP number maybe isn't recognized by your network and therefore your controller is not visible on scan list.ġ.) Change computers network adapter settings to be able to connect with controller (Step 5).Ģ.) When you are connected with controller change controllers network settings (Step 6).ģ.) Change your adapter settings back the way they were (step 7). It is advised that you write down computers network adapter values to avoid any stress later. Step 5: Changing computers network adapter settings If there is no available network, your computer and controller can communicate if you connect them with network cable.Ĭonnect your computer and controller with network cable and go to Step 5. Like it was said previously in tutorial, if there is no DHCP device present in your network, controller gets last assigned IP number. #PLANET CNC USB CONTROLLER ACTIVATION WINDOWS#īut since you had to perform Step 2 (reset controller network settings) controllers IP address is 192.168.1.200.#PLANET CNC USB CONTROLLER ACTIVATION SERIAL NUMBER#.
0 kommentar(er)
